Van Mark Sheet Metal Mark IV Industrial Trimmaster Brake
- Traditional 14" depths allows bends in the center of 28" sheets
- Xtreme stand (Included) sets up and disassembles in minutes with 6 fas pins
- Custom formed bend handles provide 4 points of consistent lift on the hinge for longevity
The Van Mark Sheet Metal Mark IV Industrial Trimmaster Brake, featuring new Power Lock™ Bar and POWERslot™ technology, provide easy setup and operation in the shop and on the job site. Non-marring vinyl strips protect metal finishes leaving clean crisp bends and hems. Our unique cam-locking system clamps to the thickness of the material and not to a factory preset. Should you ever need to fine-tune your brake, each casting comes with independently adjustable UHMW plastic wedges. While some brake manufacturers have taken away your ability to make these adjustments, its nice to know TrimMaster® gives you the choice, even if you never have to use it.
Please call 919-226-3466 to have our expert figure your next project and receive a complete quote, including shipping.
| Weight | N/A |
|---|---|
| Length | 10’6″ (3.2 m) with 11 castings each, 12’6″ (3.8 m) with 13 castings each, 14’6″ (4.4 m) with 15 castings each, 8’6″ (2.6 m) with 9 castings each |
| Manufacturer |
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.